Using the Spacefit sound
Provides optimized sound quality by analyzing the listening spaces.
Method 1. Connecting via Soundbar
To enable this function, turn on the Spacefit sound mode with the remote control of the Soundbar.
( (Sound Control) → “Spacefit sound Off” → ( Up ) → “Spacefit sound On”)
• This is available in all Sound modes.
大慈善家Timo雲拿
2023-1-27 11:30:46
謝巴打
:^(
貓狗之家
2023-1-27 11:54:08
Thx
:^(
係呀部機用左應該真係有20年 一直都算幾好聲所以就無諗住upgrade啦 係而家壞左先要換
:^(
Btw我屋企個setup係普通5.1 無空間再擺更多既喇叭 所以未必需要上到3xxx
你意思係我用1條rca插係sub仔既L或者R既in就ok，之後係avr到較speaker set?
SQUIRRELLED
2023-1-27 13:04:38
明白, 我碌過下見到部舊yamaha 6ch driven有成100w per channel under 8ohm, 以avr黎講好大力了, 依家要搵到同樣力水既要去到旗艦級先有, 唔知你用咩喇叭, 依部分要留意下
貓狗之家
2023-1-27 14:08:00
我都有擔心watt數既問題 但我見2800h個網咁寫「Discrete high-current amplifiers on all channels to deliver up to 95W per channel (at 8 ohms, 20-20kHz, THD 0.08%)—enough power to drive any speaker.」
所以我諗應該都推到掛
依幾代denon唔算有好大分別, 2xxx都係入門級, 冇preout, 7.2ch, highlight番今代3系升級左dsp chip, 令佢可以食到付費購買既dirac live, 仲有support 4隻subwoofer, 其他野冇咩變動
入門我自己會比較推3xxx, 有preout靈活性大好多, 亦都多左2條channel可以直接玩5.1.4, 如果搵到3700既清貨價我絕對大力推薦
lfe channel係multichannel signal入面專for low frequency (<120hz)既channel, 比一般既sub out carry更多information, 你可以用一條rca由avr sub out去subwoofer既L/R, speaker set番去small同岩既crossover, 唔需要用y splitter